Hi, Dialog
I am trying to implement the reconnect feature based on DA14583. My application requirement is that when the DA14583 lose connection to mobile phone, then it will start to reconnect and keep the connection as stable as possible.
因此,有参考代码来帮助这个吗?米y SDK is 5.0.3.
Thanks a lot.
Dear,
When using Connection Manager to test the DA14583 device, neither the TX Continuous Test or Unmodulated TX work. I was only able to transmit using LE transmitter Test Command. However, I desire to make a continuous test. How can I configure that to work?
Attached is the log from the test.
Regards.
Hi Dialog,
I am using custom fields of otp header to store some data as suggested :
https://support.dialog-semiconductor.com/forums/post/dialog-smartbond-bl...
Hi
We are trying to add SUOTA into our firmware, but we are experiencing a problem. When we add SUOTA to our profile, we are not able to go to sleep and we are getting around 1.2 mA. However when we remove the SUOTA profile in our firmware then the device can go to normal sleep and the consumption goes down to 30uA.
In the document AN-B-10, the step number 10 says to turn of sleep mode. Does this mean that if we are to use the SUOTA profile in our firmware then it cannot go to sleep?.
Thanks and Regards
米utahir
Hello,
is there a way to put the IoT-Sensor DA14583 into beacon mode?
In original standard project wrbl_sfl the sensor send it's data only, when it is connected to a host. But I dont want to connect the sensor first bevor sending data.
I want to send these data in a broadcast frame like Eddystone-Beacon. How can I do that?
Which function or parameters should I modify to come to that solution?
Can you give me a hint, please?
Hi Dialog,
I want to read otp using command line interface of Smart Snippets so I use the following command:
SmartSnippets.exe -type otp -chip DA14583 -jtag -1 -cmd read_custom_code -file header.hex -offset 0x2000 -length 32
Hello Dialog ,
I'm lookink for a solutions for update my DA1484 software .
I'would like to uptdate my BLE Gateway without any connexion , just use the Bluetooth channel for downloading and uptdating the version of my soft.
Can you tell me if it's possible ? My project use a DA14583 as a master to update all BLE device(583).
Hi,
there is some sample android code for testing SmartBond IoT sensor?
Greets,
Franck
Hi Dialog,
I am using Samrt Snippet toolbox(linux version) to flash the firmware in Da14583 chip.I now want to use the command line to flash the firmware, but inside the help document there is no such method specified for linux version , it is only available for windows.So I want to know if the command line interface is developed for Smart snippets linux version. If yes ,please provide corresponding document.
Regards,
Dhiraj.
Hi dialog,
I am checking the system by using the
scanning function for 7.8s as a loop, once it reach the 7.8s, I will reset the system by the following code and restart the scanning function again. However when i run it for many times, the system seems stop reset the system. Any ideas?
case GAPM_SET_DEV_CONFIG:
{
if(param->status != GAP_ERR_NO_ERROR)
{
ASSERT_ERR(0); // unexpected error
}
else
{
app_scan();
