Hello,
I have a new problem, I am using the development kit with the DA14531 module. I flashed the module with dsps_service_531.bin and I'm using your Android app SmartConsole downloaded on the PlayStore.
When I send a character with TeraTerm on my Windows computer to the module, I don't receive it on the app. But if I send quickly a lot of characters, I will receive them. For example if, on TeraTerm, I maintain the letter "a" pressed, I will receive a lot of "a" on the app after a little delay but if I press only one time the letter "a", I will not receive anything.
我没有触摸的配置anything, everything is like out of the box. The baudrate used is the default one : 921 600 bauds.
Thank you,
Noé
Device:
I found the solution. It was because of the sleep mode.
I just modified the ligne 79 in user_config.h, I put the sleep mode on ARCH_SLEEP_OFF. And then re-compiled the code.
Hi nolucas,
Please use same configuration as shown in theUM-B-088: DA145x User Manual for Dialog Serial Port Serviceand section 10.3 DA14531 Module.
If you are using extended sleep mode, the you should use UART HW Flow control (RTC/CTS) in order to wake up the device. Please note if you are using any of the available sleep mode, all the peripherals domains are shut done (including UART). This means that you cannot have any UART activity in sleep mode. Otherwise, you should disable the sleep and use it always in active mode.
Thanks, PM_Dialog