Hi,
I have been successfully downloading and running hex files to my DA14580 Basic Dev board via the USB UART interface using the default P0_4, P0_5 (Tx-Rx Pair) @ 57600 bd.
I would like to use 115200 bd. I've tried several ways without success. How would I have to set the jumpers on my board to support a 115200 bd download on P0_2, P03?
Regards,
- Mike
Hi Michael:
其中一个原因可能是,115200年of the DA14580 running at 16MHz, is about 3.5% off on the baud rate. If your PC is off by 1.5%, this could be a problem.
Thanks,
TR_DIALOG
Ok. I would like to make sure I have my board jumper-ed correctly. Is it a matter of just moving the P0_4 jumper to P0_2 and the P0_5 jumper to P0_3?
- Mike